• Secure the brackets with track attached to the brickwork and concrete with rawl-bolts
to steelwork with high tensile nuts and bolts and to timber with coach screws or
large gauge wood screws.
• Push each pre drilled strip over the bolts with the concave side facing the track.
• Hold each strip to the track using the aluminium plate, thread the M8 nuts onto
the bolts but do not tighten fully.
• Slide the strip to the desired starting place before tightening the nuts.
• If you are including Red warning strips remember to position these first.
•
To achieve 100% overlap
each strip must butt up to the next on both sides of the track, for 50% overlap
each strip should be placed at a distance from each other that it overlaps by a
quarter of the width of each strip.
• Finally trim the bottom of each strip to the desired length using a sharp knife. |
|
|