• Secure the brackets with track attached to brickwork and concrete with raw-bolts,
to steelwork with high tensile nuts & bolts and to timber with coach screws
or large gauge wood screws.
• Push each pre drilled pvc strip over the bolts with the concave side facing the
track.
• Hold each strip to the track using the aluminium plate, thread the M8 nuts onto
the bolt but do not tighten fully.
• Slide the strip to the desired starting place before tightening the nuts
• If you are including Red warning strips remember to position these first.
•
To achieve 100% overlap  each strip must butt up to the next
on both sides of the track, for 50% overlap each strip should be placed at a distance
from each other that it overlaps by a quarter of the width of each strip.
• Finally trim the bottom of each strip to the desired length using a sharp knife.
Extra help >
Face Fix |
|
|
|
It may not be possible to achieve the desired overlap, this will
depend on the width of your opening and the width of your strip |
|
Back to
Step 1 |
|